We are utilizing a VoIP infrastructure. We have a 2821 with one pri connected to it. There are 3 vg224 which connects our analog equipments. Before we switched to VoIP our dispatch department had overhead paging that was provided by valcom. Our dispatch uses a system called Positron. Which is a touch screen console provided by tarrant county 911. They pressed *51 to generate a page and it is heard thru out the police dept. Once going to VoIP they had overhead paging for a little while, but then changes were made to the gateway to allow t38 protocols to operate,which may have caused it to break. They are able to page from any Cisco phone, just not from the positron console. I verified that the CSS was correct. When a page is initiated, I can hear it click on the falcon paging, but do not see it light on the fxs port.
If there is anyone out there with any experience with a situation similar to this or any awesome ideas, I would love your feedback.
the case has been solved. Our SCCP gateway did not like *51translation pattern. This was odd considered it worked, before. But once the * was removed, dispatch was able to do paging from the positron console.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...