Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

POTS line - No Ring but call connects

I have a 2811 Router with a FXS unit installed. I have set up a POTS line on one port and assigned a DID to it. I have plugged an old analog phone into the port for testing purposes and it is known good. It has a light that flashes when a call is incoming.

Currently my issue is that I can call the number and the light flashes on the phone but there is no ring... I can pick up the reciever and the call connects. If I hang up and pick up the reciever on the analog phone like I am placing a new outgoing call I have no dial tone.

I am wondering if I have a bad port on the FXS card.

Any advice would be appreciated.

3 REPLIES

Re: POTS line - No Ring but call connects

Do you have specify the cptone parameter under voice port?

voice-port 0/0/0

no non-linear

compand-type a-law

playout-delay nominal 120

playout-delay mode fixed

cptone IT

bearer-cap Speech

If you connect your legacy analog phone on a traditional POTS line is it ring?

Community Member

Re: POTS line - No Ring but call connects

Do you have enough DSP`s on your router ?

Re: POTS line - No Ring but call connects

Try:

voice call send-recv

-nick

321
Views
0
Helpful
3
Replies
CreatePlease to create content