Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

POTS SCCP SRST TRYING TO REGISTER

Hello

I was setting up CUBE with SIP Trunk to the PSTN. This router is also set up for SCCP SRST, we have some dial-peer pots configured.

After configuring this dial-peers we saw messages trying to register.

To stop this we configure the command "no sip-register"

dial-peer voice 7000 pots

destination-pattern ........

port 0/2/0

no sip-register

!

But I can't find, how to stop register message in a e-phone dial-peer pots when this router is in SRST mode ?

CUBE_GOLD#show sip-ua register status

Line                             peer       expires(sec) registered P-Associ-URI

================================ ========== ============ ========== ============

67952                            20001      95           no         <--------------------------------!!!!!!!!

8182862940                       -1         49           yes       

CUBE_GOLD#

CUBE_GOLD#sh dial-peer voice sum

dial-peer hunt 0

             AD                                    PRE PASS                OUT

TAG    TYPE  MIN  OPER PREFIX    DEST-PATTERN      FER THRU SESS-TARGET    STAT PORT    KEEPALIVE

5001   voip  up   up                                0  syst sip-server         

5002   voip  up   up             *320T              0  syst sip-server         

5003   voip  up   up                                0  syst sip-server         

5004   voip  up   up             294.               0  syst ipv4:172.31.1.254  

20001  pots  up   up             67952$             1                           50/0/1      <--------------------------------!!!!!!!!

20002  pots  up   down                              1                           50/0/2

call-manager-fallback

max-conferences 8 gain -6

transfer-system full-consult

ip source-address 172.31.3.1 port 2000

max-ephones 10

max-dn 20 dual-line preference 1

system message primary MODO SUPERVIVENCIA

system message secondary MODO SUPERVIVENCIA

keepalive 20

!

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

POTS SCCP SRST TRYING TO REGISTER

Hi Oswaldo,

try adding "no register e164" under pots dial-peer and "max-dn 20 dual-line preference 1 no-reg" under SRST section.

Cheers,

Boris

_____ Please rate helpful posts Пожалуйста оценивайте полезные сообщения
2 REPLIES
Bronze

POTS SCCP SRST TRYING TO REGISTER

Hi Oswaldo,

try adding "no register e164" under pots dial-peer and "max-dn 20 dual-line preference 1 no-reg" under SRST section.

Cheers,

Boris

_____ Please rate helpful posts Пожалуйста оценивайте полезные сообщения
New Member

POTS SCCP SRST TRYING TO REGISTER

Tks. We add the "no-reg" command.

CUBE_GOLD#show sip-ua register status      

Line                             peer       expires(sec) registered P-Associ-URI

================================ ========== ============ ========== ============

8182862940                       -1         21           yes       

CUBE_GOLD#

CUBE_GOLD#sh run | beg call-manager-fallback

call-manager-fallback

max-conferences 8 gain -6

transfer-system full-consult

ip source-address 172.31.3.1 port 2000

max-ephones 10

max-dn 20 dual-line preference 1 no-reg

system message primary MODO SUPERVIVENCIA

system message secondary MODO SUPERVIVENCIA

keepalive 20

!

280
Views
0
Helpful
2
Replies
CreatePlease to create content