Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

pound key to bypass T302 timer problem

Hi All,

I am using CUCM 7.1. When I dial international number then press pound key to bypass T302 timer, I receive busy tone. But when I wait for 15 sec, the call is successful. is there any service parameter in CUCM to allow dialing # key to make a call immediately?

thanks

Alex

1 ACCEPTED SOLUTION

Accepted Solutions

Re: pound key to bypass T302 timer problem

U have to create another route pattern with 9.!#

5 REPLIES
Hall of Fame Super Gold

Re: pound key to bypass T302 timer problem

Why don't you change interdigit timeout to 3 or 4 seconds like most people do ?

Community Member

Re: pound key to bypass T302 timer problem

thanks for your response. But I need to use #, since most people get used to it.

Hall of Fame Super Gold

Re: pound key to bypass T302 timer problem

I think a good installation has both reasonable timeout, and pound termination.

Then, some countries use fixed lenght numbers, that you can configure if dialed frequently.

Bronze

Re: pound key to bypass T302 timer problem

Hi, just a suggestion, do you have a route pattern with the # symbol at the end, for example: 9.!#

hth

David

Re: pound key to bypass T302 timer problem

U have to create another route pattern with 9.!#

494
Views
0
Helpful
5
Replies
CreatePlease to create content