power commands not available in 2811 with 9esw module
I have a POE version of the 2811 with an HWIC-D-9ESW module. I cannot do a "show power" from global config and I cannot do "power inline auto" from interface config mode. The command is not available at all. My image is an Voice/CME image v 12.4(9). Any ideas?
Re: power commands not available in 2811 with 9esw module
The hwic part makes sense since this is a replacement hwic which they probably sent without the power module. I still have the old one that I can remove that module from.
As far as the router chassis goes the old one was an AC-IP POE model and this replacement should also be an AC-IP according to the packing slip. How can I verify this? I tried show diag and show environment and neither of these two commands shows the poe power supply. Here is the output:
C2811 Motherboard with 2FE and integrated VPN Port adapter, 2 ports
Port adapter is analyzed
Port adapter insertion time unknown
EEPROM contents at hardware discovery:
PCB Serial Number : *********
Hardware Revision : 1.0
Top Assy. Part Number : 800-26920-04
Board Revision : A0
Deviation Number : 77369
Fab Version : 04
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Processor type : 87
Hardware date code : 20071111
Chassis Serial Number : *********
Chassis MAC Address : 001e.7a6e.0e78
MAC Address block size : 24
CLEI Code : COM7R00ARA
Product (FRU) Number : CISCO2811
Part Number : 73-10258-05
Version Identifier : V05
Main Power Supply is AC with -48V
-48V supply status: OK
-48V relay status: ISOLATED
Fan 1 OK
Fan 2 OK
Fan 3 OK
System Temperature: 26 Celsius (normal)
Environmental information last updated 00:00:28 ago
SIP traces provide key information in troubleshooting SIP Trunks, SIP
endpoints and other SIP related issues. Even though these traces are in
clear text, these texts can be gibberish unless you understand fully
what they mean. This document attempts to br...
Please find the attached HTML document, download and open it on your PC.
This provides an easy to use form where you simply answer a few
questions and it will render the proper jabber-config.xml file for you
to copy/paste. There is built in logic to verif...
[toc:faq]CUCM Database Replication is an area in which Cisco customers
and partners have asked for more in-depth training in being able to
properly assess a replication problem and potentially resolve an issue
without involving TAC. This document discusse...