Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Pre-recorded alert messages

We are currently running CM 6.1 and we want to make some changes to our analog paging. We want to add a couple of pre-recorded messages to play over the paging speakers, 1 in case of fire and the other for tornado. Is this possible with this version of CM? How do I go about doing this if it is possible?

Thanks

3 REPLIES
Cisco Employee

Pre-recorded alert messages

Only possible option I can see for this is that if you're reaching the paging system dialing a DN to record that as MOH, other than that, there's no other option to record anything in CUCM.

You dial the paging DN and then put him on hold.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Pre-recorded alert messages

If we were to record the message as MOH, how would we choose which message we wanted to play when we put it on hold? And, then anyone that gets put on hold would hear this alert, wouldn't they?

Thanks

Cisco Employee

Pre-recorded alert messages

By choosing the MOH source for that DN to the message, obviously you can only select one message, that's the caveat.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
228
Views
0
Helpful
3
Replies
CreatePlease to create content