Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

prefix a number on fxs port and trunk group

Hi all,

PBXA FXO--->R1-FXS-----IP------R2FXS----PBXB FX

we used router fxs connection PBX's fxo.

When PBXA user press 6XXX( PBXB ), PBXA will auto jump to the special line connect to R1 FXS,and user heard dialtone,and Router only recieved XXX.

We want PBXA user dialed 6XXX,and PBXA sending 6XXX to router.

It looks like 6 is just a line choice number ,not a dialed number.

I tried translation-rule or translation-profile , but no helpful.

So how to prefix a 6 on FXS port ?

And, i heard a trunk group can connect PBXA to PBXB, and i cant find any configuration example for fxs to fxs.

When i configured

voice-port 0/0/0

connection trunk 6000

the voice-port become trunk mode,and flapping un and down,and user always heaed busy tone when selected special line.

3 REPLIES
VIP Super Bronze

prefix a number on fxs port and trunk group

So how to prefix a 6 on FXS port ?

It looks like this:

voice translation-rule 1

  rule 1 /^...$/ /6\0/

voice translation-profile INCOMING-PBXA

  translate called 1

voice-port 0/0/0

translation-profile incoming INCOMING-PBXA

And, i heard a trunk group can connect PBXA to PBXB, and i cant find any configuration example for fxs to fxs.

Trunk groups are used to group multiple voice-ports into a single outbound dial-peer. For example, if you had four interfaces connecting to PBXB you could put them in a trunk group and then write a single dial-peer pointing to that trunk-group.

http://www.networkworld.com/community/node/41680

Please remember to rate helpful responses and identify helpful or correct answers.

New Member

prefix a number on fxs port and trunk group

HI,Jonathan,

I already used the following configuration to translate the called number, and it does not worked.

voice translation-rule 1

  rule 1 // /6/

voice translation-profile INCOMING-PBXA

  translate called 1

voice-port 0/0/0

translation-profile incoming INCOMING-PBXA

and i used "test voice translation-rule " to proved it.

It looks almost like your configuration, i'll try it tomorrow and tell you about the result.

Thank u very much.

New Member

prefix a number on fxs port and trunk group

Hi Jonathan,

It dose not worked.

FXS port was in dial mode when user press 6,no called number sended.

483
Views
0
Helpful
3
Replies
CreatePlease login to create content