Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Prefixing "8" to incoming CLID in CM5 with MGCP gateway

Hello,

I have an BRI MGCP gateway configured, on a 2811, with backhauling of BRI messages to CM5.

When I get an incoming call, it shows up as 23XXXXXXXX.

I want to be able to present this to the end user as 8023XXXXXXXX.

However, I want to do this for only this gateway, and not system wide. (I have h.323 gateways also, that prefix "9").

Things I have tried and failed :-

In the gateway config screen, there is an option of Prefix DN under Call Routing Information - Inbound Calls

But that does not seem to work.

Creating translation patterns / CSS and partitions also does not seem to work.

Any ideas ??

Thanks

1 REPLY
New Member

Re: Prefixing "8" to incoming CLID in CM5 with MGCP gateway

RESOLVED :-

I was able to finally get this to work with Translation patterns, following another post in this forum, and a cisco web link.

The prefix DN still does not work, the way I thought it should.

My problem was, that I needed to reset the mgcp process on the gateway, for changes to take effect by issuing a

no mgcp

mgcp

whenever I made a change in CM5.

(Thanks to TIm Bryson who pointed this out to me in another post)

Thanks.

163
Views
0
Helpful
1
Replies
CreatePlease to create content