Prepend Digit configuration migration via cobras unity 8(3.3) to unity connection 9.1.1a
I am trying to migrate my unity 8(3.3) system to unity connection 9.1(1a) I am going to do a flash cut (cobras briefcase mode) to migrate my data over via cobras. I am able to get all the information trasnfered except the Prepend digits and the call input timeout from the Call Handler section. I would think that it would transfer the data over but it does not.
Cobras Export Version 7.0 build 124
Cobras Data Viewer Version 1.0 build 22
Cobras Import for CUCN Version 1.2 Build 17
There is not much information out there except for this link below where it says under unity 5.0(1) "Prepend digits option for call handler transfers"
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...