All, I hate to be a bonehead on this, but Im having somewhat of a hard time with the Presence configuration. I have this installed, but not really sure where to go or what needs to be done in the configuration. Anyone with any experience in this have a "checklist" of what should be done that they would share? Id appreciate the help.
As a side note, the guide will lead you to setup the application > Cisco Unified Personal Communicator > Settings. What TFTP ip address is suppose to be entered here? I don't see TFTP as a service active in the control panel of the CUPS.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...