Well if you integrate the Presence Server with the CCM server and install the Â¨Personal Communicator on the PC or laptop you will be able to see the exact status (presence) of the phone. For example, as soon as the phone goes off hook it will show the user as on Telephone, if you integrate it with Outlook if you have a meeting on your calendar it will change the status to "on a meeting" at the time of the meeting and will automatically change the status to available as soon as either the meeting finishes or as soon as you go on-hook.
you can use the directory or call lists to verify the status of the phone you're trying to dial. (OR CUPC or BLF, etc) but it's not possible to get it in the middle of the dialing because it simply doesn't know what you're going to end up dialing, up to that point before you press dial you can enter more digits
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...