Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Presenting the DID number to the external phones

Hi,

I have a CCM7.0 with a 2851 MGCP gateway. From the TELCO I have received the 0740111000 - 199 range numbes and I have the following problem :

When an IPphone with extension 1002 call an external number (my cellular phone) on my display is showing the

0740111000 number. I have configured external number mask 0740111XXX on the DN, and checked the box on the route pattern -> Calling Party Transformations

What else do I have to do?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Presenting the DID number to the external phones

In the GW properties page.

You can ask telco before you try anything else.

Please remember to rate useful posts with the scrollbox below.

6 REPLIES
Hall of Fame Super Gold

Re: Presenting the DID number to the external phones

Please take "debug isdn q931" - it may be a type/plan issue.

New Member

Re: Presenting the DID number to the external phones

The debug isdn q931 output is:

*Sep 15 09:23:00.973: ISDN Se0/1/0:15 Q931: TX -> SETUP pd = 8 callref = 0x0002

Sending Complete

Bearer Capability i = 0x8090A3

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA9839F

Exclusive, Channel 31

Calling Party Number i = 0x0081, '0740111002'

Plan:Unknown, Type:Unknown

Called Party Number i = 0x80, '0745625393'

Plan:Unknown, Type:Unknown

*Sep 15 09:23:01.197: ISDN Se0/1/0:15 Q931: RX <- CALL_PROC pd = 8 callref = 0x8002

Channel ID i = 0xA9839F

Exclusive, Channel 31

Hall of Fame Super Gold

Re: Presenting the DID number to the external phones

Try setting plan/type as ISDN/national, if that doesn't work call telco and ask them not to overwrite your DID.

New Member

Re: Presenting the DID number to the external phones

Can you guide me where I can find this setting ?

Hall of Fame Super Gold

Re: Presenting the DID number to the external phones

In the GW properties page.

You can ask telco before you try anything else.

Please remember to rate useful posts with the scrollbox below.

New Member

Re: Presenting the DID number to the external phones

I have called the telco and he told me I have one 0 in my external phone mask and I have to remove him. He told me I have to send 9 digits not 10.

Thanks a lot

132
Views
0
Helpful
6
Replies