Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Pressed numbers disappear...

I got a Cisco CallManager Express (CCME) installed. I got an issue with dialing a phone number. When I try to dial a 10-digit number and pause for about 3 seconds after entering the first 5 digits, it disappears. I've to re-enter the number once again very quickly before it will start dialing that number.

Is there a way that the first 5-digits remain on the screen even when I'm taking a pause of 5 of 6 seconds?

Any help or suggestions will be appreciated.

Thanks,

Yasa

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Pressed numbers disappear...

Hello,

does this happen when the phone is off-hook, or on-hook ?

If off-hook, please check the value of "timeouts interdigit" under "telephony-service".

If on-hook, the timeout should be like 10 seconds, and you should check the firmware that you are running on the phone for a possible update.

Hope this helps, please rate post if it does!

1 REPLY
Hall of Fame Super Gold

Re: Pressed numbers disappear...

Hello,

does this happen when the phone is off-hook, or on-hook ?

If off-hook, please check the value of "timeouts interdigit" under "telephony-service".

If on-hook, the timeout should be like 10 seconds, and you should check the firmware that you are running on the phone for a possible update.

Hope this helps, please rate post if it does!

106
Views
0
Helpful
1
Replies