You cannot, inbound calls are controlled by the Telco, you need to let them know which PRI you want to associated the DID range with. Usually when you have 2 or more PRIs terminated at the same location you arrange Trunk group with the Telco where they send calls on both PRIs, depending which one has available ports.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.