Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PRI channel betwen CCME and PBX Panasonic

Good day!

I want to create a channel between CCME on my cisco 2901 and PBX Panasonic TDE-600. On my PBX Panasonic i have one PRI Board with a PRI port (not T1/E1, cause T1/E1 exist for such PBX, but i dont have it), so what EHWIC module i should use on my 2901 to create a PRI channel betwen this two devices and connect it?

Thanks:)

Everyone's tags (3)
2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Gold

PRI channel betwen CCME and PBX Panasonic

leosalcie wrote:

You can use a HVWIC2-1MFT-T1E1 card for T1CAS/PRI or E1.

Regards

The correct P/N is is VWIC2-1MFT-T1E1 or VWIC3-1MFT-T1E1. Also need PVDM3-32 (minimum).

Hall of Fame Super Gold

Re: PRI channel betwen CCME and PBX Panasonic

Yes, it is.

Thank you for the nice rating and good luck!      

5 REPLIES

PRI channel betwen CCME and PBX Panasonic

You can use a HVWIC2-1MFT-T1E1 card for T1CAS/PRI or E1.

Regards

__________________________________________________
Please remember to rate useful posts clicking on the stars below.
LinkedIn Profile: do.linkedin.com/in/leosalcie
Hall of Fame Super Gold

PRI channel betwen CCME and PBX Panasonic

leosalcie wrote:

You can use a HVWIC2-1MFT-T1E1 card for T1CAS/PRI or E1.

Regards

The correct P/N is is VWIC2-1MFT-T1E1 or VWIC3-1MFT-T1E1. Also need PVDM3-32 (minimum).

New Member

PRI channel betwen CCME and PBX Panasonic

I have only PVDM3-16, isnt enough?

I can config to use only 10 time slots, not all 30, cause have only PVDM3-16, is it?

Thanks;)

Hall of Fame Super Gold

Re: PRI channel betwen CCME and PBX Panasonic

Yes, it is.

Thank you for the nice rating and good luck!      

New Member

PRI channel betwen CCME and PBX Panasonic

Thanks a lot:)

I've rating your useful posts

378
Views
0
Helpful
5
Replies
CreatePlease to create content