I am in the process of deploying a remote site with centralized CCM and Unity Connection.
My problem is that we must use the PSTN to route Voicemail, no WAN calls. That said, we have RDNIS going, and all is well, however, when I press the messages button, there is a 3 second delay before the voice channel is opened (after the call has been rerouted).
Basically, instead of hearing "Please enter your PIN, followed by #". Instead you hear, "N, followed by #"
We thought the issue was due to RDNIS; however, we hear the same exact message when just dialing the unity pilot directly, via the PSTN.
Is there a way to buffer the first few seconds of voice on the PRI when dialing this number so that the users can hear the entire message?
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4