Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

PRI / Ethernet config

Hi there,

I am looking to create a configuration to connect two PABX systems both with an PRI module in it via Cisco routers (with also VWIC-E1/T1 modules in it) over ethernet to eachother. So the PABX systems can communicate with eachother. Can somebody give me a clue where to start ? I looked on the Cisco site but really cannot find the right configuration documents.

3 REPLIES
Bronze

Re: PRI / Ethernet config

Try this link for general knowledge:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00807f54aa.shtml

Generally you would need to:

- config ip addresses on your Ethernet interfaces, make sure they can ping each other.

- Set the controllers and the voice ports.

- Set dial-peers.

The routers will need voice dsp in it.

HTH, Avner.

Community Member

Re: PRI / Ethernet config

Hi there,

The two PABX systems are not VoIP as far as i know. They are only equipped with PRI modules (E1). Do the dial-peers need to be entered at the Cisco routers then or at the PABX systems ?

Bronze

Re: PRI / Ethernet config

In the routers, everything I referred to is configured in the routers.

HTH, Avner.

237
Views
0
Helpful
3
Replies
CreatePlease to create content