PRI from Carrier with inbound caller ID name+Number
I have a CME 4.0 and we might be switching over to a PRI. The Carrier states they can send us the name and calling number for caller ID. Problem is I never seen a install where we displayed the person's name.
My question is can this be done. I did some research on cisco and found the following:
Analog FXO (loop & ground start), DID, E&M, BRI/PRI support (NI2, 4ESS, 5ESS, EuroISDN, DMS100, DMS250, and several other switch types currently supported in Cisco IOS Software), Caller ID, Automatic number identification (ANI), calling name
Does the last part mean as long as the carrier is sending us the calling partys name it will display it on the phones?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.