Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PRI-GROUP and DSO-GROUP Config Issue??

Hello Guys,

               I have a lab setup with 2 2621XM routers with VWIC-1MFT-T1 1-Port Multiflex Voice Cards in them with a crossover cable between the devices. When I go under the controller interface below to use the PRI_GROUP or DSO-GROUP commands they are not available. I only see why what is listed below. Why is that?

      VoiceGateway(config)#controller t1 0/1
VoiceGateway(config-controller)#?
Controller configuration commands:
  cablelength    Specify the cable length for a DS1 link
  channel-group  Specify the timeslots to channel-group mapping for an
                 interface
  clock          Specify the clock source for a DS1 link
  crc-threshold  Specify how many CRC errors per second to be treated as
                 severely errored second (SES)
  default        Set a command to its defaults
  description    Controller specific description
  detect         Enable detection of loopback request
  exit           Exit from controller configuration mode
  fdl            Specify the FDL standard for a DS1 data link
  framing        Specify the type of Framing on a DS1 link
  guard-timer    Guard timer (0-20) for xcsp calls - timer duration and
                 accept/reject on expiry
  help           Description of the interactive help system
  linecode       Specify the line encoding method for a DS1 link
  loopback       Put the entire T1 line into loopback
  mode           Configure the controller mode
  no             Negate a command or set its defaults
  shutdown       Shut down a DS1 link (send Blue Alarm)

5 REPLIES
Hall of Fame Super Gold

Re: PRI-GROUP and DSO-GROUP Config Issue??

You need either an AIM DSP, or NM-HDV-xxx

No DSP, no voice ports.

New Member

Re: PRI-GROUP and DSO-GROUP Config Issue??

Is there anything I need to do in order to get my card to use the DSP's on the Module?I do have a Cisco NM-1V Voice Network Module VIC in that router but, do not have card plugged in that slot. I have it inserted in regular slot. Do I need to config my controller to use those DSP's on the module or something?

Hall of Fame Super Gold

Re: PRI-GROUP and DSO-GROUP Config Issue??

That does support VWIC.

Must use HW indicated above.

New Member

Re: PRI-GROUP and DSO-GROUP Config Issue??

I looked at the cost of the DSP's can not afford them to run the VWIC'S I

purchased. Is the any cards that I can buy that will work with the equiptment I told you I have? Maybe there are PRI cards that I can purchase to get the training I need for DSO-GROUPS and PRI-GROUPS.

Hall of Fame Super Gold

Re: PRI-GROUP and DSO-GROUP Config Issue??

Check the popular auction site for savings.

Please rememeber to rate useful posts clicking on the stars below.

1314
Views
0
Helpful
5
Replies