Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PRI - In/Out (DID/DOD) Channel Limits

We are ordering a standard isdn pri (23 B + 1 B). Our telco allows us to specify that all channels are In/Out (DID/DOD), but that we can limit the max number of DID/DOD. In other words, if we always want to make sure there are 3 channels for outgoing and 3 calls for incoming, we can limit the DID to 20 and DOD to 20. This is on the CO switch side.

How do you configure the Cisco router side to limit the max channels for DID or DOD. The isdn / pri config would still have 23 channels so the config would be something like:

controller T1 0

framing esf

line-code b8zf

channel-group 1 time-slots 1-24 speed 64

clock-source line

interface serial0:23

no ip address

isdn switch-type primary-ni

isdn incoming-voice voice

isdn bchan-number-order ascending

no cdp enable

But how can I tell the router not to attempt more than 20 outgoing (DOD) calls?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: PRI - In/Out (DID/DOD) Channel Limits

You would do something like this:

dial-peer voice 1 pots

port 0:23

max-conn 20

destination-pattern 9.T

dial-peer voice 2 pots

port 0:23

incoming called-number .

max-conn 3

direct-inward-dial

hth

nick

4 REPLIES

Re: PRI - In/Out (DID/DOD) Channel Limits

You would do something like this:

dial-peer voice 1 pots

port 0:23

max-conn 20

destination-pattern 9.T

dial-peer voice 2 pots

port 0:23

incoming called-number .

max-conn 3

direct-inward-dial

hth

nick

Hall of Fame Super Gold

Re: PRI - In/Out (DID/DOD) Channel Limits

Nitpick:

DP 2 doesn't need port... try to believe :)

New Member

Re: PRI - In/Out (DID/DOD) Channel Limits

I get the concept, but actually I am looking for a max 20 in and a max 20 out so that if either maxes out, at least 3 will be available for the other (of course they could be max out too, but not eliminated).

So I think it should be:

dial-peer voice 1 pots

port 0:23

max-conn 20

destination-pattern 9.T

dial-peer voice 2 pots

port 0:23

incoming called-number .

max-conn 20

direct-inward-dial

Re: PRI - In/Out (DID/DOD) Channel Limits

Hi Cj,

Yes, this would make sure that at any time there is always at least 3 ports open for EITHER incoming or outgoing. The one I gave was for only incoming. This is probably closer to what you're looking for.

-nick

872
Views
0
Helpful
4
Replies