Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PRI inbound calls problem

Hi !

I am getting the following debug output on my MGCP gateway when I want to make an inbound call. The outbound call works fine. There is 910 extension. Any ideas?

thanks,

KO08_2812(config-if)#

*Jan 28 17:13:10.684: ISDN Se0/0/0:15 Q931: RX <- SETUP pd = 8 callref = 0x00A7

Bearer Capability i = 0x8090A3

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA98381

Exclusive, Channel 1

Calling Party Number i = 0x80, '0913885165'

Plan:Unknown, Type:Unknown

Called Party Number i = 0x80, '910'

Plan:Unknown, Type:Unknown

*Jan 28 17:13:10.692: ISDN Se0/0/0:15 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x80A7

Cause i = 0x8081 - Unallocated/unassigned number

7 REPLIES

Re: PRI inbound calls problem

Make sure the gateway has a calling search space with access to the partition assigned to DN 910.

Brandon

New Member

Re: PRI inbound calls problem

That it has. Also for inbound calls :((

Re: PRI inbound calls problem

Does the call hit a translation pattern? Is 910 a DN assigned to a physical phone?

Brandon

New Member

Re: PRI inbound calls problem

Hi!¨

910 is DN of the physical phone. Phone is in the same CSS as the gateway...

New Member

Re: PRI inbound calls problem

what partition is the Phone DN in, what partition is the GW in, and what CSS is applied to each?

also, can you give a list of partitions that are in the CSS applied to each device.

New Member

Re: PRI inbound calls problem

I would assume that no CSS is applied to the Gateway for inbound calls. Verify that the CSS is applied and that the CSS has access to the partition containing 910.

New Member

Re: PRI inbound calls problem

Hi all!

Thanks for you answers and suggestions. The thing was that below the inbound calls I had AAR calling search space enabled and filled out, so that was the problem. It stayed enabled after all possible combinations were tried out.

regards,

Goran Pilat

315
Views
0
Helpful
7
Replies