Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PRI issue with new NM-HDV2-2T1/E1

i replaced a nm-hdv2 with an nm-hdv2-2t1/e1. after i replaced the hardware and connected the PRI to the new port i cant place outgoing calls. i changed the configuration on the router.

i have the interface configured like this:

interface Serial1/0:23

no ip address

isdn switch-type primary-ni

isdn incoming-voice voice

isdn bind-l3 ccm-manager

no cdp enable

i changed the voice port to reflect the new interface number:

voice-port 1/0:23

input gain -2

output attenuation 2

dial peer like this:

dial-peer voice 103 pots

application mgcpapp

port 1/0:23

there must be changes in call manager?

thanks in advance.

2 REPLIES

Re: PRI issue with new NM-HDV2-2T1/E1

Jerry,

Are you able to receive inbound calls ?

What is the status of isdn interface ?

Can you paste a sh isdn status output ? Also include show mgcp and show ccm-manager output.

New Member

Re: PRI issue with new NM-HDV2-2T1/E1

Can you please send a sh run.Since this is a E1 you dont need the following:

dial-peer voice 103 pots

application mgcpapp

port 1/0:23

The above is needed only for fxs/fxo mgcp endpoints.

You might want to check your route pattern,route list config.A ccm trace would be useful here to determine if the call is even getting to the gateway here

193
Views
0
Helpful
2
Replies
CreatePlease to create content