Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PRI / SRST incoming calls get dial tone

I am running CCM 4.1.3 with SRST. In fallback mode, when calling INTO the PRI, I get a secondary dial tone. If I then dial an extension, it will ring the phone. What am I missing to allow a normal call from the outside to reach the intended DID? Thanks

5 REPLIES

Re: PRI / SRST incoming calls get dial tone

Under your incoming dial peer, you need the command "direct-inward-dial".

Hope this helps. If so, please rate the post.

Brandon

New Member

Re: PRI / SRST incoming calls get dial tone

Ball,

I have the following dial peer and problem persists:

dial-peer voice 7777 pots

preference 1

destination-pattern 9T

progress_ind setup enable 3

incoming called-number .

fax rate disable

direct-inward-dial

Bronze

Re: PRI / SRST incoming calls get dial tone

Believe you need to indicate the port under here as well. IE if 1/0 is your PRI, you need the command

port 1/0:23

under this dial peer.

Hope this helps.

Jim

New Member

Re: PRI / SRST incoming calls get dial tone

JIm,

Yes, I omited the port. I put the port in and also an num-exp statement, and incoming works. Thansk to all

Re: PRI / SRST incoming calls get dial tone

If you do "debug voip dialpeer" and make an incoming call, do you see that the call hits the proper dial peer?

Brandon

520
Views
4
Helpful
5
Replies
CreatePlease login to create content