cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
711
Views
4
Helpful
2
Replies

PRI to FXS Config

angel-moon
Level 3
Level 3

                   Hello Everyone,

I need to get a DID that is coming in on a PRI over to an FXS port for inbound and n calls.  The system is running  8.6.  I added the DID to the existing translation profile but that does not seem to be working.  Is that the right way to go or do I need a dial-peer?  Examples would be handy.

Thanks in advance!  all replies rated.

1 Accepted Solution

Accepted Solutions

TunNyuntMoe
Level 1
Level 1

Assuming you already configured PRI on port 0/0/0

dial-peer voice 1 pots

incoming called-number .

direct-inward dial

translation-profile incoming DID2FOUR

port 0/0/0:23

Asssuming FXS port is on 1/0/0

dial-peer voice 2 pots

destination-pattern xxxx

port 1/0/0

traslate incoming did to extension

voice translation-rule 1

rule 1 /^.*\(....\)/ /\1/

voice translation-profile DID2FOUR

translate called 1

View solution in original post

2 Replies 2

paolo bevilacqua
Hall of Fame
Hall of Fame

Yes, you need a dial-peer.

Otherwise the call doesn't know where to go.

TunNyuntMoe
Level 1
Level 1

Assuming you already configured PRI on port 0/0/0

dial-peer voice 1 pots

incoming called-number .

direct-inward dial

translation-profile incoming DID2FOUR

port 0/0/0:23

Asssuming FXS port is on 1/0/0

dial-peer voice 2 pots

destination-pattern xxxx

port 1/0/0

traslate incoming did to extension

voice translation-rule 1

rule 1 /^.*\(....\)/ /\1/

voice translation-profile DID2FOUR

translate called 1

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: