Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

PRI Trunk group help

Lets say I have 3 T1 PRI coming in from the PSTN, not an nfas group. I want to route all outbound calls to the PSTN. How do I group the 3 PRIs into 1 logical link?

2 REPLIES
Bronze

Re: PRI Trunk group help

In CM, you use the RouteGroup/RouteList for outbound calls

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/4x/42dialpl.html#wp1043613

In CME, you use the "preference" commands on your Dial-Peers for outbound calls

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/srnd/design/guide/dialplan.html

New Member

Re: PRI Trunk group help

Im not using call manager at all. These PRIs are on a 3825, the call comes in SIP g711 matches an incoming peer then needs to go out any available channel on any of the PRIs, can I group the PRIs into a trunkgroup somehow, and have just the 1 dial-peer route out that trunk?

279
Views
0
Helpful
2
Replies
CreatePlease to create content