Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Private Password Phrase CUCM Upgrade From 4.1.3 to 4.3

   I have a customer that is upgrading from 4.1.3 CallManager to 4.3.X. My customer cannot find the original "Private Password Phrase" for the original install, nor can they find the SQL password. Is there a utility that I can use to synchronize all of these passwords for their current system? I can't remember if there is utility in the utils directory on the CallManager or not.

Thanks in advance,

Jim

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Private Password Phrase CUCM Upgrade From 4.1.3 to 4.3

You can run the Admin Utility.  Here is a link to the specifics you need.  http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080557ba5.shtml.

Hailey

Please rate helpful posts!

4 REPLIES

Re: Private Password Phrase CUCM Upgrade From 4.1.3 to 4.3

It has been a while but I think you can reset the private password phrase using the Admin utility:

C:\ProgramFiles\Cisco\Bin\adminutility.exe

You only need to run this tool on the Publisher and you will want to run it after hours as it will restart services.

HTH.

Regards,
Bill

Please remember to rate helpful posts.

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

Re: Private Password Phrase CUCM Upgrade From 4.1.3 to 4.3

You can run the Admin Utility.  Here is a link to the specifics you need.  http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080557ba5.shtml.

Hailey

Please rate helpful posts!

Re: Private Password Phrase CUCM Upgrade From 4.1.3 to 4.3

Actually, I checked up on my original reply to your post and you can definitely use the Admin Utility to set the Private Password phrase.  The procedures are here:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080095225.shtml#sol3

This is a bit dated material (as 4.1.3 is a bit dated itself).  The technote is focused on the SqlSvc account but it is indeed changing the Private Password phrase.  This password phrase is used to autogen the service account passwords (among other things).

HTH.


Regards,
Bill

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

New Member

Re: Private Password Phrase CUCM Upgrade From 4.1.3 to 4.3

Bill & David,

     Thanks guys. You were both right on the mark. It turned out that they had the same password for the Administrator as the SQL password and I was able to verify that with the "adminutility".

Thanks,

Jim

287
Views
5
Helpful
4
Replies