I have Cucm 7.x and on a remote location a CME (Call manager Express).
On the cucm several phones configured with extention 10xx
On CME the phones have extention 2xx
From CUCM extention i can call an extention on the remote location
I am unable to call from the remote location the CUCM Extention
As debug i used the following:
debug voice ccapu inout
When extention 1016 calls 201 , this extention is presented as 181016 (so 18 will be the shordial code for the CME extention calling CUCM extention)
Debug output : successfull callsetup from cucm to cme.txt
When i try to cal from 2xx an 10xx extenion (calling 1810xx) i see the following on my debug(file :Failed callsetup from cme.txt)
What you see hapening is that for Cisco-username and cisco ani a increasing time the prefix is added.
at the end you see:
cisco-username=181818201
----- ccCallInfo IE subfields -----
cisco-ani=181818201
cisco-anitype=0
cisco-aniplan=0
cisco-anipi=0
cisco-anisi=1
dest=181016cisco-username=181818201
----- ccCallInfo IE subfields -----
cisco-ani=181818201
cisco-anitype=0
cisco-aniplan=0
cisco-anipi=0
cisco-anisi=1
dest=181016
i have configured the following debug on the CME router.
debug voice ccapu inout
The following dialpeer is configured on the CME:
Dial-peer voice 5 voip
destination-pattern 18.T
Session target ipv4: <IP CUCM>
dtmf-relay h245-alphanumeric
codec g711ulaw
novad
What is causing this strange issue.
Regards
Eddy Mulder
