Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Problem configuration controller E1 ++ Router 2801 + CCM 5.0

Hi,

I have a callmanager 5.0 and a mgcp router 2801 with a E1 card . In the configuration interface in the callmanager I can not set the line code to hdb3, I could do it with callmanager 4.2.

I configure the router:

**controller E1 0/1/0

pri-group timeslots 1-8,16 service mgcp

!**

But when the mgcp download the configuration the callmanager insert the line "linecode ami" in the controller E1 configuration.

What can do it?

Thanks a lot.

1 REPLY
New Member

Re: Problem configuration controller E1 ++ Router 2801 + CCM 5.0

Try to insert your controller in the slot 0/2/0

113
Views
0
Helpful
1
Replies