Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem configuration Framing CRC4 in Interface E1

Hi Guys,

My Customer have a solution IP Telephony. The Customer is working with MGCP in CallManager Version 5.1. The carrier set Framing for CRC4, but when I set CRC4 and Gateway and CCM the E1 was down, but when I set framing for no-crc4 the E1 was up and generate Slip Erros. Anyboldy any Idea what is occuring?

Thank You,

Wilson

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Problem configuration Framing CRC4 in Interface E1

Hi friend,

As Paolo said, slips errors may be due to lack of network-clock-participate and network-clock-select commands.

Now that you check with your Telco that framing is no-crc4, now check if you have network-clock-select and network-clock-participate in your configuration.

If not, please configure under global configuration mode:

Router(config)# network-clock-participate wic 0

Router(config)# network-clock-select 1 E1 0/0/0

Regards,

- adrián.

5 REPLIES
Hall of Fame Super Gold

Re: Problem configuration Framing CRC4 in Interface E1

So you need no-crc4. Slips may be due to lack of network-clock-participate and network-clock-select.

New Member

Re: Problem configuration Framing CRC4 in Interface E1

Hi Bevilacqua,

I will go verify with the carrier if they can configure no-crc4 in the the backbone.

Thank You,

Wilson

Hall of Fame Super Gold

Re: Problem configuration Framing CRC4 in Interface E1

Perhaps they did without realizing. Just set the network-clock commands correctly because you will need them anyway. crc or no crc doesn't really makes any difference to a circuit.

New Member

Re: Problem configuration Framing CRC4 in Interface E1

Hi Bevilacqua,

I Confirm again with carrier and They informed to me that is configured frame with no-crc4, but, the problem continue. The E1 is configurate as:

voice class codec 1

codec preference 1 g711alaw

codec preference 2 g729r8

codec preference 3 g729br8

!

controller E1 0/0/0

framing NO-CRC4

pri-group timeslots 1-31 service mgcp

description conexao link CTBC 35120200 (100 RAMAIS)

!

I believe that the configuration is correct, wright? or there are another parameter to be configured in E1?

Thank You,

Wilson

Re: Problem configuration Framing CRC4 in Interface E1

Hi friend,

As Paolo said, slips errors may be due to lack of network-clock-participate and network-clock-select commands.

Now that you check with your Telco that framing is no-crc4, now check if you have network-clock-select and network-clock-participate in your configuration.

If not, please configure under global configuration mode:

Router(config)# network-clock-participate wic 0

Router(config)# network-clock-select 1 E1 0/0/0

Regards,

- adrián.

3432
Views
5
Helpful
5
Replies