Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Problem in Transfer

Hy,

i have CME, i want when i must to transfer outgoing call to inetrnal phone, i didn't need to wait that the outgoing destination answers to call.

how can i do this ?

2 REPLIES

Re: Problem in Transfer

Reading between the lines I believe you need to configure transfer-system blind or full-blind under the telephony service.

To specify the call transfer method to be used by Cisco Unified IP phones in Cisco Unified CME, use the transfer-system command in telephony-service configuration mode.

See the following link for further details:-

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_t1ht.html#wp1084962

Hope this helps

Regards

Allan.

Pls rate helpful posts.

Hall of Fame Super Gold

Re: Problem in Transfer

Hi, beside the advice given by Allan, remember that to use blind transfer on system configured for consultive, just hang up, or press transfer again, after completing the number you want to transfer to.

140
Views
0
Helpful
2
Replies
CreatePlease to create content