Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem with 7921 IP phone - goes to Deceased status after a period of time

I am running on a 2821 router, 12.4 IOS code. I have 10 7921G IP phones configured on this device.

They all connect up fine and work for a period of time then go into a Deceased status and stop working.

The WiFi device is none cisco (but not by our doing), everything else is Cisco.

attached is the rtr Configuration. I also put in the 'sh ephone sum' cmd and a debug capture during the time the devices drop or go into the Deceased state.

I have seen others have similiar questions about IP phones going into this state but I have not see the answers to the problems.

1 REPLY
Cisco Employee

Re: Problem with 7921 IP phone - goes to Deceased status after a

Phones are un-registering due to keepalive timeouts. Can you setup a PC to perform packet captures between the CME router and AP?

What version of firmware are the 7921s running? Does this happen while roaming or while the phone is stationary?

-Felipe

355
Views
0
Helpful
1
Replies
CreatePlease login to create content