Okay, we have 7941 phones each with a private extension number and a the second line is used as a shared line.
If I get a call to my private DN, I can then go to Corporate Directory and then find the user i want to transfer to, enter the 'transfer' option and speak to dialled user and then hit the 'transfer' button again when ready.
BUT, if I get a call on my shared line, I go the 'Corporate Directory' and dial the person I want to transfer too, it will go out my first (private) line and not give me the option to transfer.
Was wondering if there was a way around this?
If not, then I can hit the transfer button on the incoming call to shared line and browse the Corporate Directory to transfer the call but is there an option in CallManager to extend the time I have to place the call to the person I want to transfer too. If I am looking through the Directory it always times out before I have time to find the user I want.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...