Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

problem with dial peers

First I know that am new to the IP Telephony world I am here asking for advice and help with my problem that am facing if you can guide me to what docoments will be usful I will be more than grateful

am trying to configure a Voice gateway  AS5400 to route call from ISDN  E1 to to a SIP server, I have configured the dial-peers , but when I  try to make a call form , I hear noise like a modem voice I have been  reading on Cisco website on this problem and they said all you need is  to add the command "incoming called-number  ." but still I am hearing  the same noise

ISDN E1----------------AS5400 Voice Gateway -----------------------SIP  Server

here is my configuration for the dial-peers


dial-peer voice 2 voip
destination-pattern 9T
session protocol sipv2
session target sip-server
session transport udp
dtmf-relay rtp-nte
codec g729br8
!
dial-peer voice 1 pots
incoming called-number .
direct-inward-dial
port 7/3:D
forward-digits all

if you guys can take a look at it and see if I did something wrong.

you help is highly appreciated

attach the show run

thanks in advance for you

what I am trying to do is configuring a vocie gateway to work as Internatioanl gateway for the internatioanl voice trafic therefor I am using 9T as the destination-pattern  

1 REPLY
New Member

Re: problem with dial peers

Hi,

I've not used the AS5XXX but this is my idea.

Try to change the compand-type in the voice port to a-law or u-law.

voice-port 7/3:D

compand-type a-law

or

compand-type u-law

181
Views
0
Helpful
1
Replies