Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem with in. call ISDN PRI

Hi,

I have are strange problem w/ incomming call on mgt8010->ISDN PRI->c3825->ccm5.1. So, 1-15 channels work fine, but 17-31 two-way no voice. Connection are established, no error, on debug isdn all..... but .... no voice.

Thank's for any help.....

6 REPLIES
New Member

Re: Problem with in. call ISDN PRI

What does the Show ISDN Service command display?

New Member

Re: Problem with in. call ISDN PRI

On all Layers is fine - ACTIVE.... MULTI_FRAME_ESTABLISH.... all ok

New Member

Re: Problem with in. call ISDN PRI

Global ISDN Switchtype = primary-net5

%Q.931 is backhauled to CCM MANAGER 0x0003 on DSL 0. Layer 3 output may not apply

ISDN Serial0/0/0:15 interface

dsl 0, interface ISDN Switchtype = primary-net5

L2 Protocol = Q.921 0x0000 L3 Protocol(s) = CCM MANAGER 0x0003

Layer 1 Status:

ACTIVE

Layer 2 Status:

TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED

Layer 3 Status:

0 Active Layer 3 Call(s)

Active dsl 0 CCBs = 0

The Free Channel Mask: 0xFFFF7FFF

Number of L2 Discards = 0, L2 Session ID = 7

Total Allocated ISDN CCBs = 0

New Member

Re: Problem with in. call ISDN PRI

Hi,

I have a same problem. Could you solve this problem? How? Thank you very much.

Regards,

--

Alberto

New Member

Problem with in. call ISDN PRI

Hi,

If anyone happen to get a solution for this issue? I have also the same issue gong on in my network..

Mohsin..

Hall of Fame Super Gold

Problem with in. call ISDN PRI

Please open new thread for new problem, and include FULL details about it.

244
Views
0
Helpful
6
Replies