I have issue at one client ,they have FXO card on gateway with connected analogue ,there is PLAR statement on the voice-port to send incoming calls to specific extension ,problem is when FXO port picks up incoming call it plays a solid dial tone back to the caller for about 10-15seconds before the extension rings. Is there a way of eliminating this delay ,or to not have a dial tone played back to the caller ? It is a SRST site ,gateway is MGCP.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.