i'm experiencing confusing problems with our isdn bri connection in italy. the main number ends with '60'. our did range is '600' until '619'. But on incoming calls, the called party ends always with '60'. And the confusing thing is, the gateway receives the missing digit(s) after the ISDN 'disconnect' message (sending-complete)
Hopefully this doc will help explain but the T302 is the interdigit timout. After the T302 part of the command you can also add a value in ms if you wish to remove it from the default which is 10secs, which can be a little long in cases
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.