Problem with not hearing the beep when a second call comes in on the phone.
For the past week, 2 of our sites have been experancing a rather odd issue. The issue is, that on two phones at each location, while on a call, if another call comes in for that line or for another line on the phone, the little beep sound is not heard when the second call comes in. This is not happening for any other phones on the call manager. I have tested with other phones and when calling them while on a call, the beep sound can be heard on the phone when the second call comes in.
This has only been happening for around a week or so.
We haven't upgraded the OS, CCM, phone software or made any other changes.
The only thing that had happened at both locations was the call managers had been rebooted.
I was just wondering if anyone would know how to enable the beep sound again for when a second call comes in on these phones.
The Call Manager version running at both sites is: v3.3.3
The phones that have had the issue are all 7960's
Tonight i have tested with upgrading the firmware on the 7940/7960 phones, however this still didn't make a differance.
Re: Problem with not hearing the beep when a second call comes i
thank you for the reply, however i believe what you have told me to try above, is for a CCM 4.0 or higher. I have checked and i can't find these options on the v3.3.3 CCM, however i have looked on one of our CCM4's and these options are there.
This is happening on a v3.3.3 CM.
Is there anything else i could try for the v3.3.3 CM?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...