Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

problem with outgoing calls

          Good morning,  I 've a voice-gw with 2 ISDN PRI. I need to send outgoing calls from extesions 62xx and 63xx oalways oone of these primary.

I' ve configured voice translation rules, but  not all calls are correclty sent to required PRI

Each one have suggestions?

Thanks in advance

Regards

giancarlo

1 ACCEPTED SOLUTION

Accepted Solutions

problem with outgoing calls

Hi,

okay, what do we have here. CallManager Expres? Or, CUCM?

Signaling: MGCP? SIP? H.323?

G.

5 REPLIES
VIP Super Bronze

problem with outgoing calls

Can you explain a little bit more. Do you want to send calls to a specific PRI?

Please rate all useful posts

"opportunity is a haughty goddess who waste no time with those who are unprepared"

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"

problem with outgoing calls

Yes on my voice-gtdw I've two isdn PRI  0 and 1

I want that alla calls from extension 63xx will be sen on PRI 0

problem with outgoing calls

Hi,

okay, what do we have here. CallManager Expres? Or, CUCM?

Signaling: MGCP? SIP? H.323?

G.

problem with outgoing calls

I've a callamanger 7.1 and the signaling is H323.

VIP Super Bronze

Re: problem with outgoing calls

There are two options you can use to achieve this...

1. Use answer-address on your inbound dial-peer to  match the calling number, then prefix a digit for outbound calls..

The configuration for this is demonstrated below

voice translation rule 1

rule 1 /\(.+\)/ /8\1/

voice translation profile PRI0

translate called 1

dial-peer voice 6 voip

answer-address 63..

translation-profile incoming PRI0

no vad

dtmf-relay h245-alpha

Next configure a seperate dial-peer to route calls to PRI0

dial-peer voice 7 pots

destination-pattern 8T

port 0/0/0:15

For this to work, you need to ensure that you dont have (incoming called number .) on your gateway...

2. The second option is to use a different route pattern in cucm and then prefix a digit at the route list level..

You then need to configure a dial-peer to  match the the prefixed digit and point to PRI 0

Please rate all useful posts

"opportunity is a haughty goddess who waste no time with those who are unprepared"

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
118
Views
5
Helpful
5
Replies
CreatePlease to create content