I'm just getting started at CCM (it's only been a couple of weeks) and am having what is a vexing problem for me with a simple hunt group. Running CCM 4.1(3) and just want to get a hunt group going.
So I have a couple of PCs running cisco ip communicator and they can call each other just fine. DNs are 6666 and 6669. Then I set up a line-group with 6669, use it in a hunt-list and use that in a hunt-pilot 6700. I update everything (in fact I reboot all the servers after it says there was a successful update) and dial 6700 from 6666. No joy, just what sounds like a busy signal. Shouldn't dialing 6700 send a call on to 6669 in this case?
The reason I am trying this is that I have Unity set up and can dial directly into the voice mail ports (6500 and 6501) and check voice mail, change password etc. But if I try to dial my voice mail hunt pilot (6499), just get that busy signal again. And the call never seems to get sent to Unity because I'm watching the calls on Unity's "Call Viewer". I see the calls to 6500 and 6501 in the call viewer, but not to 6499. Nothing shows up at all when 6499 is dialed. So I don't think CCM is sending the call to Unity when 6499 is dialed. So I stepped back and decided to get a simple hunt group working as described above (6700).
My understanding unless I'm missing something is that I can just take these two Cisco IPC phones that can call each other, put one in a line-group, line group in hunt-list, and hunt-list in a hunt-pilot. Then dial the hunt-pilot and it should go to the phone I put in the line-group. Am I missing something?
The only other clue I have is when I list the hunt lists, they all show Status is "Not Found". I can't find a reference what this means. Is this related to the problem or normal?
I don't feel bad asking simple questions as I get hammered with easy network questions all the time as a R+S CCIE. I am a real voice dummy so far though. Someone please throw me a crumb. :-)
Hi guys... I have the same problem... Only I have reset mine and it does show the address of the callmanager in there. Everything appears registered. I have the line group, the hunt pilot and hunt lists all done with three numbers in it. All are logged into the hunt group. When I call the pilot its just a busy signal... Any ideas?
I have found this problem a few times and the only way I can rectify this is to restart the Call Manager Service from serviceability. Not ideal but it works. Sounds like a bug to me. Anyone else seen this??
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...