I have a problem with the Fax-Server and Cisco 2811 as H.323 Gateway. I can see the incoming fax-calls on the Cisco 2811. First, the call does connect with G711?law to the Fax-Server. After then the session changes from G711?law to T.38. The Problem is that the Cisco 2811 does not send fax-data to the Fax-Server. The T38 stream is empty. Before we have shipped the Router to the US, we tested the config in Germany with an E1-line. The test was successful (sending and receiving faxes). I think we have a problem with the T1 but i don`t see a mistake in the config.
T1 line from AT&T:
Service Type: Voice Only
IDSN Version: National 2
Arrangement: PRI Voice Only CBC/CPN
D-Channel Configuration: D Channel per T
Channel Type: DID/DOD
Pulse Type: DTMF
DS1 Termination: Smartjack
Therefore I ask for assistants, can you help us, please.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4