Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem With transfer-mode consult

hi i have a shared DN on 2 telephone

9760 each and they are sharing the same DN with the commmand ephone)button 2o26,27  , the problem is the i can't use the transfer-mode consult command , it's always using the blind transfer although the commmand is set to transfer-mode consult. and i need to work with the overlapping Shared DN , and in the same time use the transfer-mode consult. Thanks alot

ephone-dn  26
number 121
description CallCenter
name CallCenter
no huntstop
transfer-mode consult
!
!
ephone-dn  27
number 121
name CallCenter
preference 1
transfer-mode consult
!

ephone  13
description Call Center
mac-address 0022.B055.D65C
button  1:21 3o26,27
!
!
!
ephone  14
description CallCenter
mac-address 0015.6379.0CA3
button  1o26,27

thanks alot

1 REPLY
Hall of Fame Super Red

Re: Problem With transfer-mode consult

Hi Mohamed,

Usually this fails if you are using Transfer System Full-Consult without the Dual Line config;

A dual-line ephone-dn has one virtual voice port and two channels to handle two independent calls. This capacity allows call waiting, call transfer, and conference functions within a single ephone-dn. Dual-line mode is supported on all phone types, but is not appropriate for voice-mail numbers, intercoms, or ephone-dns used for message-waiting indicators, paging, loopback, or hunt groups. Overlays of single-line hunt groups onto dual-line buttons are supported.

Ephone-dns are created in single-line mode if the dual-line keyword is not used. Changing an ephone-dn from dual-line mode to single-line mode (and vice versa) requires that you delete the ephone-dn and then recreate it.

Examples

The following example enters ephone-dn configuration mode to create the ephone-dn 5576:

Router(config)# ephone-dn 1

Router(config-ephone-dn)# number 5576

Router(config-ephone-dn)# exit

The following example creates an ephone-dn with the number 1001 in dual-line mode. The no huntstop command allows calls to continue to hunt to other ephone-dns if this one is busy or does not answer. The huntstop channel command disables call hunting to the second channel of this ephone-dn if the first channel is busy or does not answer.

Router(config)# ephone-dn 10 dual-line

Router(config-ephone-dn)# number 1001

Router(config-ephone-dn)# no huntstop

Router(config-ephone-dn)# huntstop channel

Router(config-ephone-dn)# exit

Hope this helps!

279
Views
0
Helpful
1
Replies
CreatePlease to create content