Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Problems routing calls between CME and CCM

Iam having issues routing calls from a phone registered to CME to a CCM phone

Calls in the CCM-CME direction works perfectly fine

On the CCM the following things have been done

Configured the CME as H323 gateway

Created non gatekeeper controlled ICT trunk

Created a route pattern for the destination and pointed to the above gateway

On the CME

configured a dial-peer with a destination pattern and session target pointing to CCM

Any Ideas what could be the problem?

Narayan

4 REPLIES
New Member

Re: Problems routing calls between CME and CCM

which one u r using for calls from CM to CME

intercluster trunk or H323 gateway?

select the h323GW in RP for calls from CM to CME and try calling from CME to CM.If still its not working check ur CSS and partition configs in CCM

Re: Problems routing calls between CME and CCM

THis is what i did

Configured an ICT trunk on the CCM

Then created CME as H323 gateway

route pattern points to the ICT trunk

If i remove the gateway config, it does not work

I think i am getting confused now as to what iam exactly using :-(

Narayan

New Member

Re: Problems routing calls between CME and CCM

Wat i said is point the Route pattern to h323 GW And wat abt the partitions of phone...

Re: Problems routing calls between CME and CCM

There are no partitions configured on the system

The RP for eg 15xxx is configured to point to CME (configured as H323 gateway)

BTW i got to make it work somehow

Narayan

234
Views
0
Helpful
4
Replies