Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

problems with ATA and CCM

Dear all,

I've been struggling a long time to get my ATA's working. first I thought the ATA wouldn't work with HP faxes, but now... I even get communication errors on Canon faxes. I want to move all the faxes from my traditional telephone central, but everytime I start to move them I get problems with te ATA's.

I've attached my gateway config. Can anyone see the problem?

the ATA's are running SCCP.

could the command mgcp modem passthrough voip codec g711alaw

solve the problem?

regards,

Gerard

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: problems with ATA and CCM

The ATA 186 supports fax pass-through. It detects the fax answer tone, disables silence suppression, and then renegotiates the coder/decoder (codec) to G.711 u-law or G.711 A-law. It does not support ITU T.38 standard or Cisco proprietary fax relay.

Refer to Configuring the Cisco ATA for Fax Pass-through mode for more information on how to configure the Cisco ATA

Super G3 Faxes are not supported because they use 33.6 kbps to establish the call. ATA only supports speeds up to 14.4 kbps.

2 REPLIES
Silver

Re: problems with ATA and CCM

The ATA 186 supports fax pass-through. It detects the fax answer tone, disables silence suppression, and then renegotiates the coder/decoder (codec) to G.711 u-law or G.711 A-law. It does not support ITU T.38 standard or Cisco proprietary fax relay.

Refer to Configuring the Cisco ATA for Fax Pass-through mode for more information on how to configure the Cisco ATA

Super G3 Faxes are not supported because they use 33.6 kbps to establish the call. ATA only supports speeds up to 14.4 kbps.

New Member

Re: problems with ATA and CCM

solution found.

"no mgcp fax T38 inhibit" did the trick

finally I can finish this VoIP project

regards,

Gerard

163
Views
0
Helpful
2
Replies