I am setting up asa 5505s for our home users. I setup everything and its working fine until I setup Qos. It will work for a couple of days but if you reboot the asa the easy vpn is disabled and it gives me some "disable aaa authentication" error when I try to re-enable it. I have to re-enter the "no aaa authentication" commands so I can enable the VPN again. Here are the commands I am using for this. Any ideas on why this is happening. (noobish)
http 192.168.18.0 255.255.255.0 inside
http 10.155.1.0 255.255.255.0 inside
no dhcpd enable inside
ip address 192.168.18.1 255.255.255.0
dhcpd address 192.168.18.2-192.168.18.12 inside
dhcpd enable inside
no aaa authentication listener http inside port www redirect
no aaa authentication listener https inside port 1443 redirect
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.