Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Procedure to restore backup in CMBE 8.0.3

Hi,

I had to reinstall CMBE, I have a backup but I do not have the procedure to load into server.

any of you have this procedure? or any link I could check?

regards

  • IP Telephony
6 REPLIES
Cisco Employee

Procedure to restore backup in CMBE 8.0.3

Hi,

The procedure to restore a BE is the same as for the CUCM. Please refer to:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/drs/8_0_2/drsag802.html#wp63188

Regards,

Tere.

If you find this post helpful, please rate!

Regards, Tere. If you find this post helpful, please rate! :)
New Member

Procedure to restore backup in CMBE 8.0.3

Hi Tere,

I have already perform restore, but after some minutes of displaying progress  reach 36 % there is a component  (CDPAGT) where it taking  too much time.. no more progress; is it normal??

regards

Green

Procedure to restore backup in CMBE 8.0.3

Hi,

May be this link will help

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/drs/8_0_1/drsag801.html

Regards

Alex

Regards, Alex. Please rate useful posts.
New Member

Procedure to restore backup in CMBE 8.0.3

Hi alex,

The CMBE´s windows hangs after 36% progress in component  (CDPAGT). I try to check  the status with command

utils disaster_recovery status but I received the error " required 1 mandatory parameters but 0 parameters were found.

I don´t kow if I should stop de restore process,  I want to be sure that the restore process is still running fine or definetly

something wrong happend

ragards

Cisco Employee

Procedure to restore backup in CMBE 8.0.3

The command should be:

admin:utils disaster_recovery status restore

You should see something like this:

Tar Filename: 2010-01-21-10-00-00.tar
Storage Location: NETWORK
Operation: restore
Percentage Complete: 90
CCM   CUCM   PLATFORM   SUCCESS   Sun Jan 24 20:37:18 EST 2010  
/var/log/active/platform/drf/log/2010-01-24-20-37-09_r_cucm_ccm_platform.log
CCM   CUCM   CDPAGT   SUCCESS   Sun Jan 24 20:37:23 EST 2010  
/var/log/active/platform/drf/log/2010-01-24-20-37-09_r_cucm_ccm_cdpagt.log

Regards,

Tere.

Regards, Tere. If you find this post helpful, please rate! :)
New Member

Procedure to restore backup in CMBE 8.0.3

Hi tere,

we try to restore by GUI, but after 36% progress th  GUI hangs and by CLI we could not check the progress.

we received the message" required 1 mandatory parameters but 0 parameters were found."

we are planning to try once but not selecting component  (CDPAGT).

418
Views
0
Helpful
6
Replies
This widget could not be displayed.