Let's say we have a small site with 25 IP phones, 4 analog devices using a FXS module in the router and an ISDN PRI circuit using a T1 module in the router. I assume a PVDM3 module with 64 DSPs would be more than enough to handle that site? Does the FXS module have its own DSP resources and we don't need to figure those in? I figure the ISDN PRI would use up to 23 DSP resources and then what's left out of the 64 on that PVDM3 could be used for conferencing, media termination point and so on. Am I thinking about this correctly? Sound reasonable (64 DSPs for a site like that)?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.