Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PSTN access code when centralized deployment with CCM

Hi,

I've got a centralized deployment with CCM6 and two sites. I used two H.323 gateways and set the PSTN access code to 9. I defined my route pattern and put my gateways in a route list. My problem is that I've got most of the calls from site B routed the site A gateway. I've thought of two access codes but what if i've got 100 sites to deal with.

Please advice,

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: PSTN access code when centralized deployment with CCM

Define your route groups

SiteA_RG = RTRA

SiteB_RG = RTRB

Define your route list

SiteA_RL = SiteA_RG

SiteB_RL = SiteB_RG

SiteA_RL = SiteA_RG, SiteB_RG

SiteB_RL = SiteB_RG, SiteA_RG

>

Create your call route partitions

SiteACalling_PT

SiteBCalling_PT

Create your route Pattern

9.@ in SiteACalling_PT w/ whatever.RF to SiteA_RL

9.@ in SiteBCalling_PT w/ whatever.RF to SiteB_RL

Does this makes sense?

Please rate post if this helps. Thanks.

2 REPLIES
New Member

Re: PSTN access code when centralized deployment with CCM

Are you using different partitions for the phones on the two sites? If they're both using the same partition and route list, they're going to use the first gateway listed. You probably want to have two route lists, eg RL_SiteA listing GatewayA then GatewayB, and RL_SiteB listing GatewayB then GatewayA.

New Member

Re: PSTN access code when centralized deployment with CCM

Define your route groups

SiteA_RG = RTRA

SiteB_RG = RTRB

Define your route list

SiteA_RL = SiteA_RG

SiteB_RL = SiteB_RG

SiteA_RL = SiteA_RG, SiteB_RG

SiteB_RL = SiteB_RG, SiteA_RG

>

Create your call route partitions

SiteACalling_PT

SiteBCalling_PT

Create your route Pattern

9.@ in SiteACalling_PT w/ whatever.RF to SiteA_RL

9.@ in SiteBCalling_PT w/ whatever.RF to SiteB_RL

Does this makes sense?

Please rate post if this helps. Thanks.

184
Views
0
Helpful
2
Replies