I am using CCM 4.2(3) and a voice gateway using mgcp. I have some analog line installed on fxo port. My concern is i want to forward all calls coming from pstn back to a specific pstn number when i recieve call on a specific analog line.
Please guide me. As for my best knowledge, it could be possible using translation-pattern but i couldn't do.
Try configuring the FXO port to send the call to a phone just like you would normally do, but in this case, make it a dummy phone or CTI route point which is then forwarded to the specific PSTN number.
This assumes you have other voice ports available for the forwarded call, and dialplan to route the call accordingly.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...