I can not make my IP phones to call through PSTN in SRST mode.
My SRST router is configured with a SIP trunk to our Call Manager. The problem is that when WAN link fails, router still tries to send all calls through SIP trunk, ignoring other configured dial peers.
dial-peer voice 1 pots
dial-peer voice 2 pots
dial-peer voice 3 voip
session protocol sipv2
session target ipv4:192.168.16.6
dial-peer voice 4 pots
As you can see from my config, when I dial 04374757 in SRST mode, router rips off 4757 and tries to call 0437 through dial-peer voice 3 instead of dial-peer voice 1. Dont know what to do with it.
It's working exactly as you have configured things. Your dial peer 3 has a destination pattern of '....' so it will match on ANY 4 digits. The destination pattern on dial peer 1 will be expecting 0 with 7 more digits, so after any 4 digits the call will be sent via the SIP dial peer.
You should always make the destination pattern on your dial peers to be as specific as possible to get around these dial plan overlaps. If possible use something like 'destination-pattern [1-9]...' on dial peer 3 to exclude the leading 0 access code for the POTS dial peer.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...