I have a PSTN Phone which is connected to the PSTN router. There are three sites connected to the PSTN router over the E1 back to back links. The three sites can call the three different number configured on the PSTN phone via the E1 cards. I have q931 debug enabled on the PSTN router and can see the calls comming in from the three sites. However I am not able to call out at all from the PSTN phone. When I enable a debug dialpeer and start pressing the digits on the phone, I cannot see any digits / debug output from the router. Any suggestion guys. Tks
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...